Daily inspection and maintenance of high-power laser die making machine

a. Before starting up every day, carefully check the pressure of the working gas and cutting gas of the high-power laser die cutting machine. If the gas pressure is not enough, it should be replaced in time.

b. Check whether the buttons of X-axis zero point, Y-axis zero point, Z-axis zero point, and laser ready status are damaged.

c. Check whether the circulating water level in the chiller is sufficient, if not enough, it must be added in time.

d. After cutting every day, check whether the focusing lens of the laser die making machine is damaged.

e. Check whether the telescopic cavity of the outer optical path of the laser die cutting machine is burned out.

f. After the daily work is completed, clean up the cutting waste in time, clean the work site, and keep the worktable of the high-power laser die making machine neat and clean.

g. After the daily work is completed, open the drain valve at the bottom of the air compressor to drain water.

h. After the daily work is completed, shut down according to the shutdown procedure, and then turn off the total power supply of the entire laser die cutting machine