Analysis of the cause: The reason for this is that there is air or refrigerant in the system of laser die making machine. Or it is poor heat dissipation, especially when the ambient temperature is relatively high.

Solution: The former needs to re-vacuate at this time, and then add the right amount of refrigerant to solve the problem. The latter tries to clean the condenser fins.

When laser die cutting machine chiller's high and low pressure are lower than normal normal pressure

Analysis of the cause: This reason may be caused by the blockage of the refrigeration system on laser die making machine, the throttling of the blocked part, the obvious temperature difference at the throttling point, and the problem can be identified by hand.

Solution: At this time, the chiller detector must be used to find out the leaked parts and carry out repairs.

When the high pressure of laser die cutting machine chiller is low, and the low pressure is high, the chiller refrigeration can never achieve normal results.

Analysis of the cause: The cause is likely to be wear in the chiller pump, resulting in a drop in power.

Solution: You need to replace the compressor at this time.

When laser die making machine chiller is working, the pressure gauge is shaken, indicating that there is moisture in the system.

Solution: At this time, you need to re-vacuate, the pumping time is not less than a quarter of an hour, if necessary, it is best to change the drying filter to completely remove the moisture in the refrigeration system.