Die line drawing on steel rule bending machine is done on the basis of the printing plate, in fact, it is to draw the line of the actual finished product on a plate containing the bleeding position.

1. The finished product size we set above is 120 x 175mm after folding, and it is 250 x 185mm after expansion on steel rule bender.

2. Use a rectangle tool to draw a rectangle with a size of 239 x 175mm. Select the rectangle and then select the card in the upper left corner of the printing plate. Press the “C” key to align vertically. Press the “E” key to align horizontally. The rectangle is at the center.

Adjust the fine adjustment distance to 0.5mm, select the rectangle you just painted, and press the right arrow to move it to the right by 0.5mm on steel rule bending machine.

Here, the front is divided into 120mm, and the back is set to 119mm, because it is afraid that the back of the beer will be over-fronted due to the inaccurate printing of the beer. After the reduction of 1-2mm, it will not worry about the finished product. There is a defect in the open back (that is, the paper on the back side as seen from the front of the card face).

In the "Position" item on steel rule bender, set the vertical value to -185mm, the horizontal value to 0, and then click "Apply to Remanufactured Object" three times. The card die line on the left is basically completed; select the four newly created rectangles on steel rule bending machine.